Pond Equipment » General Plumbing

Made from PVC, these 3-way valve are a great way to divert water between to returns or from two suction point. (jets/waterfall or skimmer/bottom drain) Also very handy when setting up a bypass on a UV light. Valve is 2 inch slip on the inside and 2 1/2 inch socket on the outside.

For the best way to maintain a proper level in your pond, we recommend the use of an automatic filler. Great for ponds with a Bead Filter.

The automatic filler should be installed as near to the pond as possible, and yet in an area where it is least visible.

Automatic fillers require little to no maintenance.

Unlike the standard ball valve found in many hardware stores, these heavy duty PVC ball valves feature a solid feeling handle that is firm yet still easy to turn. Built in union makes it simple for installations and maintenance. The entire valve is also completely rebuildable.

Featuring the same heavy duty ball valves listed above, this maniford is designed to work on the suction side of a pump. It allows three separate water sorces to be controlled indepentantly to ensure proper flow through each one. (ex. two bottom drain and one skimmer) This way, if one line happens to get plugged up, it is much easier to flush that line.

Bulkhead fittings are used anytime it is necessary for a pipe to pass through a rubber liner.

They are relatively simple to install and when installed properly are very reliable.

Bulkhead fittings should be plumbed into the pond wall so that the face of the fitting is flush with the side of the pond.

Multi-Purpose Plastic Pipe Cement.

• Clear Medium Body
• Fast Set

For PVC/CPVC low pressure sprinklers, plumbing, conduit - all classes and schedules through 6 inches in diameter.

Schedule 80 through 4-inch.

Also all ABS and styrene non-pressure.

1/2 Pint

Swing check valves are very low resistance check valve ideal for koi ponds. Allows water to flow through it when the pump is turned on, but then shuts closed when flow stops. A must have valve before a pumps that is above water level. One of these 2 inch valves comes standard with every Advantage Bead Filter.

Designed to go at the end of the 3 inch pipe coming from the bottom drain, this valve is serves as a way to get any debris that might get hung up on the 3 inch to 2 inch reducer out easily without any cutting of the pipe. Simple unscrew the the top cap and remove the blockage, then reinstall the cap. MUST BE INSTALLED ABOVE WATER LEVEL.

Flex pipe is available in 1 1/2 inch, 2 inch and 3 inch diameters. Great for those awkward angles when plumbing the filter together or when running the jet line around the pond. Buy it by the foot or save some money and buy a whole 50 ft roll. Comes in black only.

These reducers are used to reduce the outlet of the jet line into the pond, which should be 1 1/2 inch pipe, to 3/4 inch female thread. This will now allow an Eductor or Mazzi jet to be screwed into it. The standard 1 1/2 inch to 3/4 inch reducer bushing can be found at some hardware stores and is for use with a 1 1/2 inch bulkhead with threads on liner ponds. The Special Reducer is designed for gunite or concrete ponds where the 1 1/2 inch pipe for the jets extend into the pond. The pipe is cut off flush with the plaster and then the Special Reducer is tapped into the inside of the 1 1/2 inch pipe. The Special Reducer fittings are only available from Sacramento Koi.

Standard 2 inch union. Recomended to be installed on the suction and pressurized sides of the pump to allow for easy removal of the pump if need be.